How To Shape A Bonsai Tree With Wire

The wire should be wrapped around the branches at an angle of 45 degrees.

How to shape a bonsai tree with wire. Open the wires if it bends from top of branches. Stop watering the bonsai a few days before wiring the trunk and branches. Wire from the base of the branch to the very tip before starting to wire the other branch. Bonsai wiring should not be done to a plant or left on through the peak growing season.

Grab one wire with nose pliers at the top leaving the half cm then twist your wrist to right again hold this wire a little below and twist your wrist to left. With the other hand begin to coil the wire at a 45 degree angle. It will take a few months before the branches are set in their new shape. By wrapping wire around the branches of a tree you are able to bend and reposition the branches.

A tree that hasn t been watered will have. With one hand hold the wire firmly to the base of the trunk. Wiring bonsai trees wiring is a crucial technique to train and style bonsai trees. Now the wire have some zic zac shape.

Wrap aluminum or copper wire around the trunk of the tree beginning at the base of the tree and wrapping it at a. Cut a piece of wire about one third longer than the trunk. The wire manipulates the limbs and after a few months can be removed and the tree will stay in its new position. Remember however that wiring puts a stress upon the tree and should be done only with healthy plants.

Basically copper or aluminium wire is wrapped around the trunk and branches to form the shape of the tree you are trying to create. Do it till the end of wire. Anchor the wire by pushing one end into the soil at the base of the trunk right to the bottom if using only a shallow dish. Mastering basic bonsai techniques.

This way the wire will enable the tree to grow thicker while remaining its new shape. Bonsai wiring in fall or winter is best. Start with wrapping the wire around the trunk and proceed with the first branch. By doing this the wire will hold the branches in place and you are able to control the growth of your bonsai tree into you desired shape.

How to wire shape bonsai plants 1. In this video we go over the basics on wiring a juniper bonsai tree branch. Apply by sticking the wire into the soil at the base of the trunk and winding it up the tree to the first branch at a 45 angle.